If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Met up with Dean and Tony and got 4 flights in on the Protos. Once the sun came out it was a great session and even managed to pull 180.5 amps through the Kontroik 120HV. Was good to see Dean maiden his Protos and watch some very nice flying.
I got four flights in with my KDS Agile 7.2 with it's new hobbywing 160A V4 ESC fitted (fantastic ESC) and a couple of flights with my Goblin 630. It was very windy but the flights went without incident.
Got out this afternoon for a bit. Sadly had to say goodbye to my mighty raptor 50 but I had one really good last flight with it! Managed 3 on the protos max and then realised my tail belt has finally worn out!
MSH Protos Max V2. Vbar Neo, Cyclone 715, zeal, talon 120
MSH Protos 500 FBL. VX1e, Zeal 480
Trex 150. In one piece and flying well........for now!!
Futaba 14sg
Met up with Dean and Tony and got 4 flights in on the Protos. Once the sun came out it was a great session and even managed to pull 180.5 amps through the Kontroik 120HV. Was good to see Dean maiden his Protos and watch some very nice flying.
[IMG][/IMG]
Rich
- Michalis - OXY HELI - XNova Motors -
...and let the flying be second nature!
Fine weather to start spring off so plenty flying over the weekend, 6 hrs on Saturday and the same on Sunday. Looking good out the office window just now so hopefully get up after work for some more
Hi yes I'm using the MSH 500Kv motor and running about 2060 (ish) head speed. Now all the packs are run in and after some advise I'm going to up the head speed to 2100 (ish). I fly more sport style at the moment with a few light 3D moves, so I'm not really pushing the packs that hard.
Hope this helps
Rich
SAB Goblin 700C - Black Nitro NEO,Kosmik, OS105, MKS, Cyclone V-Control
It must be the season to maiden a Protos Max! I got through a few packs today whilst setting-up the Bavarian Demon and by the end of the second pack it felt rock solid.
I swapped the Kosmik ESC from my TDR into the Protos, so the TDR needed a bit of tweaking with a smaller ESC.
About to start the build on my Protos Max, so there will be another maiden soon! Today had 6 flights on my Logo 480, just have it setup nice and tail nice and solid.
Comment