I bet. Fixable?
Announcement
Collapse
No announcement yet.
Did YOU fly today??
Collapse
This is a sticky topic.
X
X
-
Originally posted by Rotorwheels View PostI bet. Fixable?XL Specter 700, Vbar Neo
RJM DTS 700 Nitro, 91 SZ, Vbar Neo
Synergy N606, 55HZ, Vbar Neo
SAB Drake Nitro, 105 HZR, Vbar Neo
Oxy 5, Vbar Neo
www.Hely-Shop.co.uk
Lynx Heli Innovations
Comment
-
Re-kit with blades £475XL Specter 700, Vbar Neo
RJM DTS 700 Nitro, 91 SZ, Vbar Neo
Synergy N606, 55HZ, Vbar Neo
SAB Drake Nitro, 105 HZR, Vbar Neo
Oxy 5, Vbar Neo
www.Hely-Shop.co.uk
Lynx Heli Innovations
Comment
-
Today i got three flight on the 7Hv, three on the Trex 600 and two on the 500... that's all the batteries i have. I've just about got them all re-dialed in after updating firmware on the 3GX units. I count a good flying day as one where I take all my models home in the same number of pieces as they started the day; so today was a good dayGoblin Kraken, SoXos Strike 7, XLPower Specter, Goblin Black Thunder T, Goblin 700 Speed, Goblin 770 Comp Carbon, Trex 700X, Kasama Dune, Henseleit TDR
Comment
-
2 flights this morning before work but had the luckiest of escapes, landed, walked back to the pits and took the canopy of then heard a wosh and flame! Quickly ripped the packs out found the link wire on the lipo had moved and rubbed on the carbon frame.
The frames are smoothed over but will be putting some fuel tube on the edges now.
Not to fussed about the packs as they where 2 1/2 year old and have served me well, tiny bit of charring on the front frame pieces but will put some new ones on anyway.
This could've of ended so much worst
Stay safe guys.
ImageUploadedByTapatalk1403454176.691069.jpg
ImageUploadedByTapatalk1403454194.168893.jpg2nd place sports class, Helifest 2015
Proud member of Frontier RC Association
Gaui X7 Formula Vbar
500 Pro Vbar
Trex 450 L Dominator Vbar
Oxy 3 Kbar
Comment
-
Did I fly today? No, I simply crashed
Luckily only a 450 so not so expensive as others have experienced.Last edited by Just hovering; 22-06-2014, 06:13 PM.David
_________________________________________________
SEMAS Flying Club
sigpic
Comment
-
Flat out nose dive into the deck after a stall turn, I think it went in on its side then it bounced and landed on the head lol. I'm not sure if it was dumb thumb, something failing or my tx (just back from HH 10 packs ago due to rf board failing), I just zoned out. I remember pulling back on the elevator and nothing happening, it just plummeted from around 50ft, hit throttle hold just as it was abouts to touch, from what I can see it needs.
A boom
main shaft
feathering shaft
front umbrella gears
upper main bearing block
main gear
main blades
canopy
prob a few bearings
rear skid
possibly main grips
Ive got most of it so it's not too bad on the wallet, Over 100 flights without decking it
So not all that bad
if anyone hasn't already I think a lot of it was saved by nylon screws on the skids and canopy mounts otherwise I'd have probrably ended up with frames too.Attached Files
Comment
Comment