Help with Raptor 50

[electricsceadu]

remove the tail hub and blade assemble off your x50 and try it on the rappy
no cost envolved to replace the parts
then try the rappy parts on the x50
and see what happens

and yes you can and very often get tail blades out of balance
the other problem with tail blades is the mounting hole goes oval and this can cause the one blade to run in a bigger circle than the other

[Rob99]

He said it was old and worn (well hopefully talking about the Raptor) and that it would help my flying to look at a new model which i did with the X50.

I agree though Noel is brilliant with Raptors and also set up my X50. I am going over Banbury to the caravan site near where he runs his lessons from in April so may take it over for him to look at before i make a decision.

did noel give any advice to what could have been wrong at the time?
as noel knows raptors inside out

[Rob99]

remove the tail hub and blade assemble off your x50 and try it on the rappy
no cost envolved to replace the parts
then try the rappy parts on the x50
and see what happens

and yes you can and very often get tail blades out of balance the other problem with tail blades is the mounting hole goes oval and this can cause the one blade to run in a bigger circle than the other

Tried this and still the same. Thought the metal tail grips on the X50 may reduce the tail blades going out of track but no difference.

I will strip the whole thing down to parts and reassemble. I would like to get to the bottom of this and find the problem.

Once again thanks to everyone for your help.