T-Rex 500 Info

[ChrisB]

Mr Models has one Carbon 500 in stock Now,i am wanting single pack per flight hoping to run 5s as the new 10s charger can do two at once

[ChrisB]

Just an update,G10 frames are 1.6mm same as 600N Sport ones and seem very sturdy,head build went OK,easy so far

[Boggy]

looking good for sunday Chris!!!

[ChrisB]

Ron

I will have it with me but doubt i will have chance to finish it

Piccie or two

[Dashik]

You've had that all day and thats all you've managed? Your Fired! Give it to me now, I'm confiscating it for your own Good!

[Ashley Davis]

he put it in front of the telly and watched it all day

[ChrisB]

No.my camera is shite and thats where the most light is

[ChrisB]

Couple more piccies,i love the silver on gloss black..

Easy build..

[Ashley Davis]

you got same prob me and trev had, servo cables to damn short.

[Symon]

Nice one Chris

I prefer the red canopy for sure!

[Sesame]

well im stuck with the yellow, but after I started last night at 8 till about 12.30 then and hour or so this morning, ive now got the deans I need so I can get her finished and mmaybe even in the air later.

[Tim Procter]

well im stuck with the yellow, but after I started last night at 8 till about 12.30 then and hour or so this morning, ive now got the deans I need so I can get her finished and mmaybe even in the air later.

Looking good Tony..

Its blowing a gale here so no testing in this neck of the woods today.

[Sesame]

just been flying the K3d ant the rappy. it was blowing fairly strong

[ChrisB]

you got same prob me and trev had, servo cables to damn short.

Whats the crack with running the servo wires near to the esc using Spektrum,i have stuck the esc inside the frame on the right hand side under the battery tray and i didnt want servo wires externally unecessarily and getting the front servos around the main gear is a pain so i have got some extension leads and run the front 2 servo wires forwards under the battery tray on the inside of the left hand frame then along the bottom inside of the left frame past the motor to the rear..

I know it was never advised to run servo wires near a motor or esc but wondered if with more modern motors and esc`s whether this rule still applies..

Will be using an Ar6200 Rx

Edit.....

Got my bleeding obvious head on now,i have re routed cables well away

[Smoothound]

Wots with all the time they've had to develop the 500 and its still got swash to servo links that run at stupid angles...unless of course my mate built his wrong of course