Theres one!!!

[Nick B]

Yes in all flight modes Nick, I found it lazy to start with and indirect. I would 0 the expos in the Vortex and then add it in the Tx to your liking

That's the best way for me i think

[Andy from Sandy]

Which servo?.....Is this a throttle servo im not using?...where is the setting.

Although i have been through the whole lot it's easy to get lost through thinking TOO much lol.

When using an ESC plugged into SV5 even though you are not using it drive a servo you need to set it analogue servo type. There is a FAQ on the Spartan website.

[Nick B]

This one?

Spartan RC

[Andy from Sandy]

That'll be the one.

Blimey, my previous post barely makes any sense at all having just read it again. lol.

[Nick B]

That'll be the one.

Blimey, my previous post barely makes any sense at all having just read it again. lol.

Now you say,i read it 10 times before it half sunk in lol

All done now,it was a painful wait with it all hanging off the heli,i needed some double sided taping to be done,part of the build process i normally enjoy

Well,heres how it looks

[Andy from Sandy]

It is hard to see but do you have the slave lead from the ESC plugged in?

[Nick B]

Yes,click on pic then click again to magnify

Hot glue at the ready!

[Andy from Sandy]

Hot glue at the ready!

Good move.

[Nick B]

Should i use the thicker black sensor pad?

[Andy from Sandy]

So far on all my models with the v-bar I have used the Ming Yang aka Ripmax servo tape and I have had no issues. I think it is best to firm mount the sensor first and see how it goes. Soft mounting could allow the sensor to move around in hard maneuver.

[Nick B]

I have some ming yang here,will use that.

[mattie-lodge]

That's what I used to mount my sensor

[Andy from Sandy]

Be prepared to relocate the sensor, sometimes it is required. The top shelf might be better and it is no big deal to not have the datapod permanently mounted.

[Nick B]

Be prepared to relocate the sensor, sometimes it is required. The top shelf might be better and it is no big deal to not have the datapod permanently mounted.

Pod is there temporarily.Think Mattie used the bottom shelf,he flew his today

[mattie-lodge]

Pod is there temporarily.Think Mattie used the bottom shelf,he flew his today

Yeah, mine is mounted on the bottom shelf. The supplied thin tape didnt work to well as its mounted across the join of the frames. The Ming yang worked much better