If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
even a 500 is sometimes a bit of a bugger to auto, ive auto'ed a 250, that was very hard, 450 wasnt to bad, with vblades, IMO the best blades you can use to auto a 450 with
Chris 'CHUNK' Newby
Trex 700E DFC_Align BL800MX_CC160HV_BL700H_BL750H_Spartan VX1n_Haiyin 5000mAh 12s
Trex 700E DFC_Align BL800MX_CC160HV_BL700H_BL750H_Spartan VX1n_Haiyin 5000mAh 12s NAHC-Newton Abbot Heli Club, check out the website at WWW.NAheliclub.org.uk
ALIGN-TREX.CO.UK team pilot
LYNX team pilot
SPARTAN team pilot
Dx18
That's really useful. I'm not rushing to do a real auto. Lots of other ways of breaking a heli. There doesn't seem to be an escape option either as by the time you know you've misjudged it, its too late. Perhaps you could tune a model in Phoenix so it works properly. Does raising the headspeed help in real life as it does in Phoenix? I suppose full negative collective doesn't make the rotors turn that well either.
I suppose full negative collective doesn't make the rotors turn that well either.
This is one thing you can experiment with without risking your helicopter.
Wait until there's a good breeze blowing, then take your little helicopter and hold it vertically, with the bottom of the rotor disk into the wind. As you change the collective values, you'll find the rotor speed will change dramatically. There is usually a "sweet spot" where the rotor speed will be noticeably higher than anywhere else---there are other factors in the auto but it seems to me that you want the collective set around that point.
Neil H: Certified compatible.
P&M Quantum 912 Golf Charlie Foxtrot Bravo Mike Trex500ESP/ds760;BeamE4/Jazz/2221-8/GY401;WOT4e
Contributor to http://www.rcheliwiki.com
That's really useful. I'm not rushing to do a real auto. Lots of other ways of breaking a heli. There doesn't seem to be an escape option either as by the time you know you've misjudged it, its too late. Perhaps you could tune a model in Phoenix so it works properly. Does raising the headspeed help in real life as it does in Phoenix? I suppose full negative collective doesn't make the rotors turn that well either.
When pulling back gradually on the elevator, the H/S will increase.
Best thing to do imo is watch the Curtis Youngblood video first if you havent already, and when you do attempt an auto for the first time, ask someone who is competant at doing them to stand with you and guide you through it.
They arent difficult, but they arent as easy as Phoenix makes them out to be.
Comment