Tweet
On saturday I was fixing my 450 and at one point I put my TX down as I laid it on the bed it started flashing and beeping as if it had low batterys or had been switched on with TH hold or something anyway during this I picked the TX up again and it started beeping again only to switch heli model to my 600. I didnt think much of it and put it back into the 450 model and ressumed on to the 450.
About 5 minutes ago I decided to raise the swash on my 600 to get a little more pitch anyway I switched the TX on and then the 600 and played with the sticks as I normally do just to check etc and I noticed that all wasnt right, what has happened is my I apply throttle/pitch the swash leans forward as if im using the right stick and when I pull back the swash moves backwards again and its the same on the right hand side, I move ail left and right and its fine but if I move forward the swash moves upwards and again same if I bull back the swash goes down.
If I reverse Elev in TX it sorts the throttle/pitch out but it reverses the actual Elev on the heli.
This is all very strange and has reset my trims and thorttle hold but hasnt touched the sub trims, travel adjust or anything like that.
Ive just checked my RX and the plugs are all correct, no one has been tampering with my TX or 600.
No doubt if I copy the settings and move to a new model it will sort the issue but bolders suggests I send it to HH.
About 5 minutes ago I decided to raise the swash on my 600 to get a little more pitch anyway I switched the TX on and then the 600 and played with the sticks as I normally do just to check etc and I noticed that all wasnt right, what has happened is my I apply throttle/pitch the swash leans forward as if im using the right stick and when I pull back the swash moves backwards again and its the same on the right hand side, I move ail left and right and its fine but if I move forward the swash moves upwards and again same if I bull back the swash goes down.
If I reverse Elev in TX it sorts the throttle/pitch out but it reverses the actual Elev on the heli.
This is all very strange and has reset my trims and thorttle hold but hasnt touched the sub trims, travel adjust or anything like that.
Ive just checked my RX and the plugs are all correct, no one has been tampering with my TX or 600.
No doubt if I copy the settings and move to a new model it will sort the issue but bolders suggests I send it to HH.
Comment