Does anyone else with a DX7 hear a buzzing comming from the Tx when its turned on? Since I purchased the set it has done this and I am now wondering if there is some kind of fault with it as I have lost full control of right rudder! I am going to put the heli back onto the 35mhz set to check rudder operation but I thought I would ask about the buzz first.
Announcement
Collapse
No announcement yet.
DX7 buzzing
Collapse
X
-
I too had a similar thing with right rudder but no buzzing, if i was hard over right ie doing chaos id lose the tail but if i backed off a bit i regained control WEIRD. Have sent my dx7 to horizon today fer repair as its not outputting an rf signal and i caused me to crash my k3d on friday. So fingers crossed its fixable!
Comment
-
You can run the Vibe on 140° CCPM on the DX7.. I did
I think there's a thread on here about the correct p.mixes to put into the Tx...
Otherwise, once Real Raptors knowledgebase is back up and running, it's in there
Cheers,
RobTeam Align, Midland Helicopters, Optifuel, Cyclone Blades, Scorpion Motors, Thunder Power, Savox Servos, JR Propo
| 3D Championship
Comment
-
Again mine does the same (buzzes) and has since I purchased it in Feb 2008. I was worried at first but its been a brill piece of kit and no issues with it.

TREX 600 N PRO - awesome and superb to build -
Trex 450 se v2 - Brilliant heli.
Trex 500 -
tested hovered (24.03.08) - brill 
Blade 400 - tricky little blighter - Rebuilt more times than i can remeber.
Blade cx2 - The start !
Comment
-
I've got 2 dx7s. Both buzz a little it'd completely normal. Unless it's particularly loud, then I'd get it checked out. You need to put your ear to it to really hear it.
As has already been said Horizon are very good turning stuff around and are very helpful so if you are concerned send it back to them.Slow Mo Blade 550x
Comment



Comment