Rave 450 Flybar cage

[est1976]

On the amendment sheet to the manual it says to use some washers to take the slop out of the flybar cage, it incorrectly states them at being 2mm when if I have identified the correct ones they are actually about 0.25mm each.

Without these washers fitted there is infact slop but im finding with them the flybar cage is too tight and doesnt seesaw very freely at all. If I use just one of the washers I still have a very small amount of slop.

Whats the solution? Do I need to source some 0.20mm washers or something?

thanks.

[nick36]

hi i had the same problem with mine i used 1 washer on each side but filed a slight amount off each end of he cage rods so they pulled in that extra bit been runnig it like that for a few months now....... and love it
hope this helps

[est1976]

somebody else has the same issue and posted on rr, the reply from one of the rave team was to use just one washer a small amount of slop shouldnt make any difference.

[moonmanflyer]

Got both on mine and is free moving and no slop virtually, they obviously vary quite a bit