Bit of advice on 130x

[tomatwalden]

Cheers Tom,

Can you tell me what o-rings you used and where, iv gone by what it said on rc hero but had some spair.

Have played with the expo etc but she's very livley, almost impossible to keep her in a steady over without wobbling around! I'm not the best pilot mind haha

I got the O rings from rc-hero. It's a complete set for both the main head, swash and tail connectors. I only applied the swash and head O rings, hence had the smaller tail O rings spare too.

To be fair, the 130x is a lively heli - expo and DR will tame it down, but with stock settings, it can definitely shift!

[Curryzz]

I got the O rings from rc-hero. It's a complete set for both the main head, swash and tail connectors. I only applied the swash and head O rings, hence had the smaller tail O rings spare too.

To be fair, the 130x is a lively heli - expo and DR will tame it down, but with stock settings, it can definitely shift!

Yeah same, I have the rc hero ones aswell, I didn't use all of them ither.

Will double check iv done it correctly.

Yes it does go someFast little heli

[tomatwalden]

Did you take off the stock O rings!?

[Sburv]

Bit of advice on 130x

Rather then o'rings, I used the additional canopy grommets that came with the model. Soon sorted out the head wobble my 130x developed.

[Curryzz]

Did you take off the stock O rings!?

Yes I replaced them? Should I have double them up?

[tomatwalden]

Bit of advice on 130x

No. That's right. Wanted to check you didn't double them up.

[Curryzz]

Ok good, thanks for your help will fly it today

[Curryzz]

Put two Lipos through the 130x and I felt quite pleased at how it performed.

I evan managed to do a couple of pirouettes(Yes Im not very good)

[jimmyhorns]

Steady steps forward.

I nearly piroette deathed today lol

[Curryzz]

Steady steps forward.

I nearly piroette deathed today lol

Lol, yeah I find my Nano is rubbish but this 130X was a lot more stable,however I got a bit confident and through it round and it was all over the place, struggled to get it back under control.

Is that what you mean by deathed?

Did you decide to order the blades for my 300x in the end?

Paul

[brin]

I was well pleased with the 130 today.I am very busy sorting out my new club so finding time to fly is difficult.but i managed to get two flights with the 130 only the second day i have had it .after yesterdays maiden i added a bit more expo and it was fantastic .even managed a couple of flips without issue.What a great little heli :-)