Trex600N Engine Mounting

[mateymark]

Hi Guys, I need some advice.

I put the engine back in my TREX the other night after fitting a new clutch (Thanks Baz).

When I had put the 4 (rear facing) bolts in position holding the engine to the mounts, I could move the engine up and down quite a lot (at least 1 mm.)

I didn't know whether to push it up and then do the bolts up or just let it sit in its bottom position with the bolts in and then tighten them.

I wondered what you guys did with the TREX.

This time I tightened the bolts up with the engine in mid position. All seems ok but I would like to know what others are doing.

Thanks

Mark

[trvo]

I just put mine in with it resting on the bolts...

Trev

[nightstalker]

i bolted my mounts to the engine first then put the engine in, never had a problem