Advice please: Initial Throttle/pitch curves 700 LE???

[easyRobin]

I'm finishing the build of my T-Rex 700 LE.

What would be a good starting point on the throttle/pitch curves?

On my 600 NSP I run the Align governor with the DX7.
What would the settings be on the 700 with the same governor/DX7?

Thanx for your views!

Ciao,

[easyRobin]

Nobody?....

[Tom Burgess]

on a OS/Align 90 with an align gov, the endpoint for around 1850 HS is 73% while 1950 is around 80%

however, the curves dont have anythng to do with this and you should set your curves first.

In normal I'd start with somethng like 0 35 45 50 60 and adjust from there. once you are happy with the hovering speed in normal you can match your idle up curves.

then engage your gov

[easyRobin]

Ok, thanx.

So what would the 3 headspeeds be for N/I1/I2?
Is that around: Normal: 1750, Idle Up 1: 1850 and Idle Up 2: 1950?

I am actually amazed by the low starting points, does the Align 90 have so much power?

Ciao,

[Tom Burgess]

Ok, thanx.

So what would the 3 headspeeds be for N/I1/I2?
Is that around: Normal: 1750, Idle Up 1: 1850 and Idle Up 2: 1950?

Yeah thats what I would set for.

I am actually amazed by the low starting points, does the Align 90 have so much power?

They are just a starting point, you will refine them. It would be no good to have the motor hitting its target HS at too high a barrel setting or there would be no throttle left for load.

for now, dont worry about your gov, get your curves right then engage the gov