MicrobeastX and Futaba 12fg

[Alex Hawtin]

Hi guys, I realise it's probably a bit of a stupid question but...

Does the BeastX Microbeast work with the Futaba 12fg using a standard 2.4 reciever? if so is there any specific things I should look out for

Heli will be a T-Rex 600 Nitro FBL.

Thanks in advance!

Alex

[dani_r]

Just use the 617FS receiver if you're not fussed about S-Bus

7ch FASST Futaba P-R617FS/2-4G - 7ch Rx 2.4GHz - Transmitters and Recievers Receivers - ALIGN-TREX.co.uk

or the 6203SB if you fancy the S-Bus version.

6-18ch FASST S-Bus (HV) Futaba R6203SB Receiver - Transmitters and Recievers Receivers - ALIGN-TREX.co.uk

I would recommend this one as it's literally a couple of wires going in to it. Keeps the wiring down and is ideal for FBL setups. Just make sure you follow the instructions in the Bx on using an S-Bus receiver (Page 18 of the V3 manual).

Hope that helps!

[bish]

Works fine Alex just plug and play ! What's happened with the jets ?

[NiceBlades]

I have mine running on. 9c super, don't see how it's going to be any different as its a standard receiver. Watch out to plug the wires in the correct slots, I had one of my gyro wires connected in the wrong one in my 500' took me ages to find it was the problem, Ian.

[Alex Hawtin]

Thanks for the replies guys!, as I'm using the 12fg I can't use the S.bus system from looking on Futaba's site.

Glenn, Still doing the jets and picking up a new 50ccer next week but I fancy a new venture and I've fancied getting into Heli's for a while

Thanks again guys!

Alex