Servos buzzing

[Planehazza]

This is probably a stupid question, but at 4.8v are servos more likely to buzz under load than at 6v due to less power?

The links on the fusion are still a little tight, but even with the blades off, the servos are buzzing and whining as if they were binding at centre stick. This is using a 4.8v NiCAD Rx pack for setup.

Cheers!

[Sao]

I'd say they will buzz with 4.8 or 6V digi servos are noisy buggers and will sit there buzzing away even with no load on them.

[Spanner]

The buzzing is just a digi servo trying to find it's correct position, so whether it's running 4.8v or 6.0v they are still going to try to find this position and buzz.

[Planehazza]

Cool cheers

[LaurenceGough]

It'll be the same, different servos make different noises depending on the brand. Nothing to worry about either way...

[RcRotaryMadness]

The buzzing is very annoying but as long as they're not buzzing like a hive of bees then they should be fine, as said even when theres a small load on them its just trying to maintain its position..