What i did was make my own wedges to reduce the throw on the throttle.
i used 1.5 mm carbon trex 600 tail fin to be precise,
cut this into 25mm by 5mm rectangle drill a hole bag in the centre.
then place them in the spaces above and below the throttle mechanism as you will see the holes are already there to screw them down.
i used the two screws from inside the tx right at the top they don't seem to be holding much and i dint have any that fit lol,see picture.
go into the service menu and recalibrate the throws here is the link to do that it is easier than you think just read this info carfully and exit the menu how he suggests
JR 9XII service menu - RC Helicopter Wiki
Edit: as pointed out by turbod you have to turn on reduced throttle in the service menu before you calibrate the sticks.
cheers
lee
i used 1.5 mm carbon trex 600 tail fin to be precise,
cut this into 25mm by 5mm rectangle drill a hole bag in the centre.
then place them in the spaces above and below the throttle mechanism as you will see the holes are already there to screw them down.
i used the two screws from inside the tx right at the top they don't seem to be holding much and i dint have any that fit lol,see picture.
go into the service menu and recalibrate the throws here is the link to do that it is easier than you think just read this info carfully and exit the menu how he suggests
JR 9XII service menu - RC Helicopter Wiki
Edit: as pointed out by turbod you have to turn on reduced throttle in the service menu before you calibrate the sticks.
cheers
lee

(Now with 3GX)
Comment