that dam bolt again!!! lol

[squeaky pete]

i got full stainless in my frames, nevr put one in the top jesus bolt, just the bottom, wont be doing that again lol!!!

[5exi]

i got full stainless in my frames, nevr put one in the top jesus bolt, just the bottom, wont be doing that again lol!!!

You should be fine using them on your frames, it's just areas like blade grips / main shafts it's not a good idea due to extra loads.

As stainless will snap when the load gets to much but them nice black bolts that comes in a kit tend to only stretch.

[jiberjaber]

You should be fine using them on your frames, it's just areas like blade grips / main shafts it's not a good idea due to extra loads.

As stainless will snap when the load gets to much but them nice black bolts that comes in a kit tend to only stretch.

I would caution against even using them there, with HT bolts, if you over tighten, then you get some indication before it all goes pear shaped... with SS bolts, they just snap straight away, usualy just past the head so you cant get them out....

If you can always get to the rest of teh bolt, then they may be worth the risk, but if they are fitted to a blind hole or similar, then I wouldnt.

YMMV