Revolectrix PL8 - How to charge 6v Lead Acid?

[muscleflex]

Hi all - my PL8 says it can charge a 6v lead acid battery. Can anyone who has the charger or familiar with the charger tell me how?
In my menus- I can only see 12v or 24v Lead Acid. I need 6v don't I?

I tried to access the presets but I didn't see a 6v option in there neither.

Thanks

This is the battery I want to charge:
https://www.tayna.co.uk/LSLA4-6-Luca...ery-P8921.html

[waveydavey]

Can you not alter the cell count for the 12V to give you what you need

[muscleflex]

No - don't think I can...... it's fixed at 12v... I'll check again now actually.

[waveydavey]

Just looked in the manual and it says 12V only so where did you see the 6V

Edit : Apparently you can

Yes, see library preset 24. It defaults to 12 cells but you can change it to 6 cells.
To use it copy it to an unused perset. See the Edit function in the CCS software.

[muscleflex]

Ahh so I have to use the software on the PC? Kinda makes sense I suppose. I tried doing it on the charger but I couldn't change the voltage. I'll try and do this and will update.
Thank you for helping!

[Gixxer]

Just looked in the manual and it says 12V only so where did you see the 6V

Edit : Apparently you can

Yes, see library preset 24. It defaults to 12 cells but you can change it to 6 cells.

6 cells is still 12V

[muscleflex]

6 cells is still 12V

Hi - but I need 6v (I think!)

[james_2k]

Change to three cells then

[muscleflex]

Change to three cells then

can't change the templates - that's the problem! it's either 12v or 24v!

[Mark_T]

.. you can add a new one though...

[kenny d]

What I did was connect two 6v batteries in succession , that makes 12v , I used the old battery & linked the new to it