If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If you want it to go from the Rx liPo then it's the wrong lead for the job (the Electriflyer one). The whole point of having dual inputs into the FBL is because a single servo 'JR' type plug is only rated for about 4A, so you need two of them. If you use a standard Y lead then all the current still has to go through a single servo type plug before splitting into two, so you don't gain anything.
You need a special Y lead with a higher rated connector (Deans, XT-60, EC3 etc). You really want heavy duty 20AWG wires too.
My RX lipo has a xt60 connector on it so could do with something like WaveyDavey suggested but a different lipo connector. Might just have to soldier my own as I have all the stuff I need, if I can't find one?
Thanks Waveydavey, that's a very kind offer. I'm going to try soldier it myself and see how it turns out. If it goes really wrong you might be hearing from me
Comment