Newbie

[Darwil]

righty then... my DX6i and msR X but for some reason i'm having trouble binding them. Could some help me trouble shoot this problem?

You first need to set a slot up in the dx6i for your heli using the settings advised with the heli or from off here, then turn the tx off, put the battery in the heli and connect it. You should now get a rapid flashing led in the heli. Now hold the trainer switch up on the back lhs of the tx and switch the tx on, when you see BIND in the display lit the trainer switch go and after a few seconds the led in the heli should stop flashing and stay on, its now bound.
ps make sure the tx is 5-6 feet away from the heli, this can sometimes cause a problem with binding.

[AndyX]

To bind your MSRX to your DX6i you need to plug battery onto MSRX and put down onto flat surface.
Then hold the trainer switch on your TX on by pulling towards you. Whilst this is held on then power on your TX. Hold the trainer switch on for a few seconds and then release. You should see bind in your LCD display. After a few seconds your MSRX will stop flashing and will be bound to your TX.
You will need to programme settings into your DX6i for your MSRX for it to fly correctly.

I was using the switch on the other side, thanks for that.

Do you know where I could find these settings for DX6i? I have got the heli to hove but seem to lean to one side so iassume i need to trim it?

Sorry for all the all the questions.