Big Ask

[supamansuper]

I know its a big ask but,does anyone have a diagram of how to install the servos into a spektrum ar6200 reciever?The reciever on my cp gold had number rather than Ele/rud etc.
Cheers,
Jim

[Jamin_00]

Ch 1 =Throttle
Ch 2 =Ail
Ch 3 =Ele
Ch 4 =Rud
Ch 5 =Gear
Ch 6 =Aux

[Mart61]

I'm not sure a diagram will help. However you will do no harm using trial and error. You should be able to figure out which are your elevator and gyro leads so stick the lead from the gyro into the RUDD port, the elevator into the ELEV port and just check out all the others.

I'd use a 4.8v power source tho - you don't want the motor spooling up on you if you use the LiPo and ESC to power the Rx.

[supamansuper]

Is ch4=rud the gyro and ch5=gear the extra wire that comes from gyro?

[Mart61]

if you are using the gear channel on your Tx to control your gyro, then yes.

[supamansuper]

What goes in Battery/bind and aux1?
Am i right that throttle is the esc?

[EtheAv8r]

I make a short servo extension lead and plug it into Bat/Bind so when the installation is completed and the RX is buried away, it is still easy to re-bind after making settings changes, and connect a standard RX battery for setting up so the motor won't run.

Aux1 is Pitch

Throttle is ESC/bec yes

[Milamber]

I make a short servo extension lead and plug it into Bat/Bind so when the installation is completed and the RX is buried away, it is still easy to re-bind after making settings changes.....

SOOOO simple when you think it through. I have a couple of 250's where, if I had thought to add a short extension, I would have had much less trouble. Time to order some very short extension leads. Thanks.

M.