Tweet
I could always speak to Century and see if they'll restock them as they are unopened.
Holst, what I've purchased is a Laser Gear Puller which has a combination of either 2 or 3 leg. I've been using it in 2 leg as I've seen clutch pullers for RC engines that are similar. However it just starts to go sideways as there is no give on the clutch cover and plate. The last attempt has put some indentations onto the clutch plate cover.
I was considering drilling off the clutch plate (perforating close the shaft with small drill bits) but gathering that the clutch is made of a material harder than my drill bits
Holst, what I've purchased is a Laser Gear Puller which has a combination of either 2 or 3 leg. I've been using it in 2 leg as I've seen clutch pullers for RC engines that are similar. However it just starts to go sideways as there is no give on the clutch cover and plate. The last attempt has put some indentations onto the clutch plate cover.
I was considering drilling off the clutch plate (perforating close the shaft with small drill bits) but gathering that the clutch is made of a material harder than my drill bits
Comment