spinning out of control

[JA3llis]

Hi again I am having some teething problems with my king 2. It had a brushless setup and extream idler with hh gyro. I put the heli on a spinning board to check all was ok. The heli just spings anti clockwise I can counter act this with full oposite pitch and it just stays centered. I have run out of movement on the rotor now. Any ideas the motors running in the right direction boom is straight so I am wondering if the gyro could be the prob. Thanks

[J-S-Q]

Are you in Heading Hold mode and do you have the gyro direction set correctly?

When you are doing this test, are you spooling up to full head speed, or just keeping it on low throttle?

[JA3llis]

I have done it now thanks i just had to make some slight adjustments to servo and tail its not spinning now thanks. I am a real noob and I really need some help with setting it up as its all out of **** and I dont want to try it till I no for certain it aint just going to smash into a thousand pieces.

[GravityKills]

if you could find someone who can test fly the heli, it would make a big difference.
For a beginner, a heli that is setup badly makes it ten times more difficult. Even if everything is fine and only the trims are off, it'll be much harder.

[J-S-Q]

I'm not familiar with the King 2 heli myself but it might be worth checking out some of the build videos on the Helifreak site for the various different helicopters. I found them absolutely invaluable when I first started and they should give you a good understanding of how to set up a heli:

Finless Bob's Helifreak Tech Room - HeliFreak

[liambaker996]

DANDEMAN HAD THE EXCACT SAME PROBLEM WITH HIS HBK2 PM HIM HE WILL GIVE YOU YOUR ANSWER :d
LIAM

[dandeman]

DANDEMAN HAD THE EXCACT SAME PROBLEM WITH HIS HBK2 PM HIM HE WILL GIVE YOU YOUR ANSWER :d
LIAM

I sold that... never found the problem

[unwind-protect]

With the Esky helis it's usually because the servo hasn't been moved to the right position on the boom, and/ or the pitch control links are on the wrong side of the blade (they should be on the leading edge, rather than the trailing edge---this gives you a much larger useful pitch range).

[JA3llis]

I have found the problem thanks all it was the boom it was bent like a banana lol and if anyone is around the chesterfield sheffield area I would like to hear from you as I could do with some help with setup etc. I have been watching some vids on setup and mine is miles out I have ordered some gauges and we will see how we go thanks guys