Pred main blade's and tail

[Disc]

Guys,

I did have Rotor Tech main and tail on the predator gasser but does anyone fly any other make on a predator gasser ?

Just wounded what kind of options I may have

[robgt]

Any 90 size blades (690 or 710) should work - and probably better than the Rotortechs too - I seem to recall them not being the stiffest of blade, shall we say

Cheers,
Rob

[Disc]

Any 90 size blades (690 or 710) should work - and probably better than the Rotortechs too - I seem to recall them not being the stiffest of blade, shall we say

Cheers,
Rob

Seen the blades at the right price then

[Si_B]

You broke it then ???.

[Disc]

You broke it then ???.

Oh yea with a Stupid error one I have never made before

Totally ****ed about it

[robgt]

Stick some V 690's on it and beat it until it cries

LOL
Cheers,
Rob

[Disc]

Stick some V 690's on it and beat it until it cries

LOL
Cheers,
Rob

I've seen the blades its getting need to check bolt hole though

[robgt]

What are they?
Where?

Cheers,
Rob

[Disc]

Going 710 mains

http://www.fast-lad.co.uk/store/710m...oot-p-510.html

[robgt]

Nice one

Cheers,
Rob

[Disc]

Nice one

Cheers,
Rob

Ah but spotted the blade root to thick

so now looking at these:

http://www.fast-lad.co.uk/store/wide...25)-p-494.html

[robgt]

I thought the Pred blade grips were 14mm?
It's ages ago since I had one, but I thought I used blade grip spacers to fit the blades?

Maybe not...
Cheers,
Rob

[Disc]

I thought the Pred blade grips were 14mm?
It's ages ago since I had one, but I thought I used blade grip spacers to fit the blades?

Maybe not...
Cheers,
Rob

I measured and it looks like 14mm would be to big

Yes you have spacers for rotor techs there 10 mm by the looks of it

been on phone to fast-lads and in the end I had to get:

http://www.fast-lad.co.uk/store/710m...des-p-363.html

and tail blades are:

http://www.fast-lad.co.uk/store/carb...ade-p-506.html

going to cost about 95 pounds in total delivered and thats to bad in my book.

rotor techs 710's are 120 alone! and tails are 28.99 !

so saving over 50 pounds on blades alone

[robgt]

Yes you have spacers for rotor techs there 10 mm by the looks of it

Aah - that would explain that then

Went for Radix instead!
I'm using the Stickbanger 710s on my Vibe, once it's back in the air... (long story short - I encountered an electrical short which grounded it, inverted, followed by funky chicken 'cos hold wouldn't work - minimal damage but the parts that died (clutch/bell/main shaft, etc) are disgracefully expensive making me think twice about owning it... it just flies so damn great though!)

Good luck with yours!
Cheers,
Rob

[Disc]

Question

Looks like my boom got bent slightly



So I'm going to assume its not really flyable like that ?