powering carbsmart through gain channel

[tonystevens]

im trying to connect power to my carbsmart at the mo.theres two ways i can go about this one being a y-lead through aux2 and the other using the +- on the gain channel.
my problem is that i dont want to use a y lead as it makes for a messy wiring job but im using a csm sl720 gyro and instead of the usual single signal wire going into the gain channel,csm gyros use a three wire lead going into the gain channel.
so my question is can i still power through the gain channel by cutting the +- wires out of the gyro gain lead or do they have to stay?
hope this makes sense

[heliward0]

are you running a gov???
the gov only needs the sense wire not the + - so remove the + - wires from the plug and put your carb smart wires into it,, job done this how i did mine on my 600n

[tonystevens]

are you running a gov???

yes,revlock30 through aux 2

[heliward0]

my first post edited mate,,

[heliward0]

or revlock dont need to be on aux unless your running 2 different rev ranges so you can do away with the aux bit of the gov but it will still give govorning to engine,

[tonystevens]

never thought of that ,cheers
so i could do this through aux2 and it wouldnt affect anything ,i wouldnt have to alter any tx settings?

[heliward0]

never thought of that ,cheers
so i could do this through aux2 and it wouldnt affect anything ,i wouldnt have to alter any tx settings?

do you mean by removing aux or by useing the wires??

[tonystevens]

sorry, by using the wires.

[heliward0]

no it will not upset anything,,,

[heliward0]

but just double check before you sart/fly your heli,!!