TriCopter ARTF

[jamiem]

This is a home-build Tri, based on the design on rcexplorer.se, with the arms made from hardwood, the motor mounts made from ply, and the centre plates from G10 (circuit board type fibre sheet). The arms fold back for easy storage and carriage, and if it takes a knock, the worst you will do is to split an arm, which is a 5 minute job to replace. It flys on a 3s 2200 pack for about 7 minutes, and is very easy to fly (if you can fly a heli, this will be a breeze). The rudder mount is made from a Synergy N9 tail hub and grip, connected to a hitec metal geared servo - ball raced mount in the grip, works a treat I used this for FPV which worked really well, although the FPV gear is now removed and sold. For some video examples of what I filmed with it, click on the youtube link in my sig and have a browse through

The installed electrical gear:
3x Turnigy 860kv motor's spinning 10x4.5 fibre laced props
3x Turnigy 20A ESC's
KK multicontroller
Hitec 82MG rudder servo

Also included is a USB AVR programming interface, for changing/updating the installed firmware on the KK board, 2 spare motors (one has a notchy bearing) and 2 spare ESC's! There are 3 spare 10x4.5 props and 4 spare 8x4.5 props, as well as spare motor shatfs, and 2 lots of mounts and prop adaptors.

I've spent a LOT of time on getting this flying nicely, it is literally RTF minus a lipo and receiver (futaba 617 available too).

I'm asking £150 delivered for all the above including the spare motors, esc's, props, usb programmer etc. Paypal with fee's paid please

[jamiem]

Toooo the top

[jamiem]

Bump! Open to offers

[jamiem]

Price dropped to £125 posted

[jamiem]

£110 posted with fees paid, Bargain! The KK controller was £75 alone

[jamiem]

Bump

[bikerflier]

PM sent.