Spectrum binding

[higgsy09]

Hi guys, sorry if this ha been covered, did have a quick look, ive just changed over from 35mhz to Spectrum 2.4

just setting everything up, cant work out where i can put the bind plug.... using ar8000, align 2 in 1, do you plug the battery into a spare aux channel and use the bind plug in the bind/data channel? sorry complete noob to these, also polarity of the servos.... signal wire to top of receiver?

thanks

[higgsy09]

sussed it done binding, plugged in servos.... loads of buzzing is this normal or is it because its not all set up properly yet?

[millerman]

plug the bind plug into the bind data port mate and follow the destructions

[Eckchaz]

Unplug a servo from rx and plug the power cable in its place..
Put the bind plug in the batt/bind port and hold the bind button on Tx until Rx light goes from blinking to solid.. pull the bind plug out of the receiver and then power off.

And if ur using Align servos.. Yes, its normal and they buzz alot!