oops, where do all the wires go?

[fredted40x]

Hi,

Have just taken my stock receiver out of the twister 3d storm, to put a new 2.4ghz receiver in and now im lost,

can anyone tell me where all the wires go?

sorry


thanks

[sacko]

Look at the heli head on.

Aileron is front right
Pitch is left
Elevator is at the back

Gear and rudder is gyro.

[fredted40x]

have got loads of wires, so far i have two from the gyro into aux 1 and rudder, the gyro says to plug it into aux or should i stick it in gear?

now i need

gear(not sure if needed)
elev
aile
thro
batt

there are two wires coming out the thing you plug the battery int, any ideas what they are?

ps its the ar6200 receiver.

ps oops, i feel stupid now, there is only one coming from esc, the other is from another servo, 2 secs

nope still confused, mmy servos must be in different places or something, i have one on the front

otwo in the middle (left/right) and one at the back under the tail.

[westray]

Elevator servo--front with two control rods
Looking from front
Pitch servo--Back left,fitted to aux
aileron sevo -- back right,fitted to aile
two cables from gyro-single wire to gear other wire to rudd(single wire is a signal wire so goes to inner pin on rx
BEC cable from speed controller to throttle
Check the movements of your servo's after connection and adjust as required using swash mix and reverse(disconnect motor before doing this)
Hope this helps

[fredted40x]

Thank you!!!

Its all working!