dx7 sticks

[tonystevens]

Does anyone here know whether you can get smaller sticks for the dx7?
the sticks on my dx7 are set at the shortest length i think, but i think even shorter sticks would be better for me.

[Bruinbear]

Any MacGregor/JR fit replacements will fit. The optional ones on the DSX12 are pretty short, but not cheap.
Mike.

[tonystevens]

anyone using these? they look a bit fat for pinch


Fast Lad Performance

[TrexMADuk]

Have these myself, great for a thumb flyer like me....

[Butuz]

Yeh they look like thumb sticks to me, I might have to give them a go because despite having tried to pinch I always end up using thumbs and seems to do ok with it!

Butuz

[tonystevens]

I'd agree they look like thumbs sticks but text says pinch also.dont think they'll do for me.what im after is just a smaller version of the dx7 style stick.

[Bruinbear]

Those were not what I was talking about. These are the suckers ...
JRC47129 Genuine JR Short Gimbal Stick Ends In Silver [JRPA144] £10.49
Fast Lad Performance

[glen_j]

Those were not what I was talking about. These are the suckers ...
JRC47129 Genuine JR Short Gimbal Stick Ends In Silver [JRPA144] £10.49
Fast Lad Performance

they look like they could do some damage

[Tim Procter]

anyone using these? they look a bit fat for pinch


Fast Lad Performance

I bought these to try not long ago Tony and absolutely hate them.

Cheapest way is to get a file and rasp a little from the bottom of your existing sticks (equal length each) and try them again.

I did this and they are perfect.

PS: If you take this route be careful not to over do it.

[tonystevens]

cheers tim,i'll try this cos i like the feel and am used to the stock stick and if i balls them up ill blame you!

ha-ha only kidding

[Mart61]

I've gone mine down as low as they go too.

[Rctintin]

tonystevens If you know how much you want off them, send them to me and i'll turn them down on the lathe for you mate.

[Tim Procter]

tonystevens If you know how much you want off them, send them to me and i'll turn them down on the lathe for you mate.

Rob.

They are made of very light alloy and around 6 strokes with a fine file should do the job.

Nice offer though..

[tonystevens]

thanks for the offer rob very kind of you but as tim said it should be a simple enough job with a file

cheers anyhow

[Hangar-7]

I use 1/4 in Polythene tube as sleeves over the stick and I get a better feel for the stick now.