Ar7000 receiver setup

[Grant85]

Could anyone help me please?
I have a Spektrum Ar7000 receiver and hitec 5245mg servos and a futaba Gy401 gyro with a Futaba s9254 tail servo.So what plugs where on the Receiver?
Cheers Grant

[robgt]

Channel 1: Throttle
Channel 2. Aileron
Channel 3. Elevator
Channel 4. Rudder (Plug the gyro in here)
Channel 5. Gyro gain (Plug the yellow gyro lead in here)
Channel 6. Pitch (Aux1)

Connect your rudder servo to the gyro socket (on the leads).

Cheers,
Rob

[Grant85]

On the receiver it says 'Gear', so i wasn't sure if this was where the gyro gain lead went or not,Thanks Rob i'm all clear now

[EtheAv8r]

On the receiver it says 'Gear', so i wasn't sure if this was where the gyro gain lead went or not,Thanks Rob i'm all clear now

Yes - you will use the Gear switch to control the Gyro Mode - Normal or Heading Hold. The Gear channel travel points will be set to determine the Gain setting on the Gyro.

[liambaker996]

if you look in your txc handbook it should tell you look at the futaba one i think it is?
coirrect me if i am wrong
liam

[robgt]

Futaba receivers have slightly different channel assignments - Throttle is channel 3 and Ail/Ele are promoted to 1 and 2.

Otherwise, they're the same
Cheers,
Rob