Announcement

Collapse
No announcement yet.

JR to Spektrum centres?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • JR to Spektrum centres?

    I've switched a fair few helis over between 35Mhz and Spektrum on my PCM9X2 with Spektrum module and just plugged and played.

    Finally found an Rx that would fit in my Mini Blade so I've just been sorting that out. When I come to power up and bind the 1st Rx is FUBAR Get it replaced at the shop and this one binds fine but one wing servo and one tail servo the centres have shifted by 40 and 24 points of sub trim respectively. Why's that then? Anyone else seen this or is it common and I've been lucky with various helis?
    Phil
    "Be who you are and say what you think...
    Because those that matter...don't mind...
    And those that mind... don't matter"


    Blade 130x, Park Zone Mini Sukhoi, EDF F16 thingy, some Gliders and some broken stuff

  • #2
    37 views no comments

    Obviously it's just another dodgy Rx then lol
    Phil
    "Be who you are and say what you think...
    Because those that matter...don't mind...
    And those that mind... don't matter"


    Blade 130x, Park Zone Mini Sukhoi, EDF F16 thingy, some Gliders and some broken stuff

    Comment


    • #3
      I only had minor trim changes when swapping over from my 9XII to a DX7, I also had minor trim changes again swapping from the DX7 back to the 9XII with a Spektrum module fitted, it wasn't any where near as bad as your experience
      Steve H

      http://www.himbletonRChelicopters.co.uk
      Trex 600N, Trex 700N, now 3G!, Raptor E550 now in fetching Hughes 500E, Trex 250, Trex 500CF, Trex 550E 3G, Beam E4, Outrage 550, Logo 500 3D.

      Comment

      Working...
      X