ff9 ar7000

[opc]

Hi all,
I have a question that's plank related(sorry).I have an extra300 with servo's on each aileron and on each elevator half.I have tried to set this plane up using an ar7000 the only problem I have is that I carn't get the elevator to work because with the the ff9 the servo's plug into channel 2 & 8.
Is there anyway in the ff9 that I can change the elevator to work on say channel 2 & 7 or is it not possible to do this?

Thanks
Steve

[Mike W]

Stick a Y lead in there for each of them unless your running flaps / air brakes

[opc]

Hi mike w,I thought off that but the servo's are the same way on each side so one goes up and one goes down.I supose I could turn one of the servo's round but I'm not sure I'll get the same movement out of them because the linkages would be different lenghts.

[Mike W]

No need .. just swap the arms about on them .. The ailerons are easy .. Mine are Y leaded in the wing... the elevator then just use as 2 sep channels and mix the 2 channels in the Tx .. Hope this Helps....