DX7 Switch Mod

[madmackie]

hi all im thinking of doing a switch mod on the dx7 as i think the trainer switch is really poor you cant feel it properly in the cold and it is in a really bad position i have found pictures of the mod on another site the problem i have is i am going to use an jr trainer switch off an old tx i will have two wires from the board in dx7 but there are three connections on the switch which two do i use or has anyone any other suggestions or done this mod before thanks in advance pete

[cjcj1949]

Switch DX7

hi all im thinking of doing a switch mod on the dx7 as i think the trainer switch is really poor you cant feel it properly in the cold and it is in a really bad position i have found pictures of the mod on another site the problem i have is i am going to use an jr trainer switch off an old tx i will have two wires from the board in dx7 but there are three connections on the switch which two do i use or has anyone any other suggestions or done this mod before thanks in advance pete

Youve got a single pole 2 way switch there. The two wires youve got want to be either connected or not. Pole should be centre and each end will be a contact. Ues centre and end.Use a meter or a bulb and battery if you want.
Post the picture if you could.

Chris

[madmackie]

here are the pictures of the switch mod i have spoken to horizon hobby but they didnt seem to know or understand the problem all they said was they would email spektrum so the switch i have is a spring loaded trainer switch from an old jr tx i use middle and one of the end connections thanks pete



if you cant view these sorry

[cjcj1949]

Have you got the web address of the picture.

[cjcj1949]

Thanks