Tweet
Hi guys, how can i tell if my Receiver has got the new quick connect installed on it? I know it sounds self explanitary but how long would a quick connect system take to connect and how will i know?
Cheers
Lee
Cheers
Lee
-
-
easiest way is to switch the transmitter on, then the receiver, let it bind once, then quickly switch the receiver off and back on again. if you have QC then the bind lights on the RX's will start flashing to indicate a power dip on the current bind. -
when you switch the rx off and back on again then you should get some flashing leds in the rx.
The info is somewhere here in the forum, or on horizon's website.www.heli-extreme.co.uk a good club in south Sheffield
600n pro BeastX Align DFC head bls251, 3xbls451, align gov, 600d, 2in1
trex500, BeastX DS510 swash, Beast X cutr and carve head DS520 HK3026-1900, Align 425D blades, 5S4200 rev'trix, K&BDD dampers, AR6200
"450" superframeSTK, align DFC head v2tail, hk22281-8 on 3S 9650w9257gear commander 55A align 325D hitec digitals Tarot ZYX, AR6100e
MCPX kbdd tail and blades, miniaviation bats
Dont spend more flying models than it costs to fly for realComment
-
See the youtube clip on my first post.
http://www.rcheliaddict.co.uk/showthread.php?t=9279
Basically switch off the receiver, then on again within 30 sec.
If you have the Quickconnect update then control should resume, but the lights will flash indication power was cut.
Tim.Comment
-
so i take it a RX without quick connect will not flash the leds? What does that do instead then?
Cheers
LeeComment
-
The led just stays on, or it might just lock up!!!
Tim.Comment
Comment