Blade 400 connections to AR7000 RX

[RotaryOne]

It looks as though the 7000 is going to fit into the 400.

The question about connections is that there is a lead from the ESC and another from the MOTOR, but which one goes on the throttle connection on the 7000? Presumably the one from the ESC. But then where would the motor connector go please? Since rud, elev and aile are all taken, and looking at the DX7 manual, then presumbly it has to be either AUX 1 or AUX 2.

Thanks in advance for any help.

[Mike W]

The Blade uses a brushless motor so the connection that runs from it is more than likely the one to program the motor ... The one that comes from the Esc is the one that needs to sit in the rx ....Unscrew ya motor so ya cant throttle up and plug it in to the RX ... I only has experience with futabas so its always been channel 3 for throttle ....With the motor off the drive wheel ya shud be able to try both connections without killing ya self in the process ... Hope this helps

[RotaryOne]

Many thanks, Mike. Much appreciated.
Nigel