Replacement servos for Trex 450 pro FC

[jjjjdup]

Hi

I am just about to start building my 450 pro DFC.
I want to stick the align servos in my Blade 300x - will they work in the 300 x ?

Now, that means I will have to get new ones for the 450.
These need to be better than the ones that come with the kit, so that at least I feel I am upgrading !

What would you guys reccomend - Savox perhaps ?

Thanks for any advice

[scallybert]

MKS DS95s seem great - but they are expensive & heavy. Fast, powerful, no slop.

DS92A+s are lighter & cheaper, but I had to upgrade the power system.

DS545s are lighter & cheaper again - but may have caveats. I think they need to be run at a lower pulse rate.

I'm not sure Savox are any better than Align (?).

[jjjjdup]

Perhaps I am being silly.
Maybe I need to just use the Align servos on the Trex ( no 3D yet. still only doing figure of 8's) and just get new ones for the 300x.
What would be good for then 300x that is not MKS prices?
Thanks for the reply so far.

[450man]

I think Savox and Align are the same aren't they?

I have just upgraded the cyclic servos on my 450 Pro to Hitec 5065MGs. They seem much smoother than the Aligns and easy to repair. Response seems snappier too.

I didn't change the tail servo but will do if and when I damage the stock Align one.

[jjjjdup]

Think I'll go with the hitec 5065mg's after reading reviews.
Recommendation for the tail rudder servo?
Thanks guys

[milly0812]

Replacement servos for Trex 450 pro FC

The standard ds520 does a good job ;-)

[jjjjdup]

Thanks

[aamacgregor]

I've got a Hitec 5084MG tail servo on mine, but I attached it using a 450SE tail boom mount and control rod, as it doesn't fit in the 450 Pro tail servo mount.