Raptor 30 & Revlock 10 ratio setting

[Ade_Law]

use same pitch curve on all flight modes. set normal to disable the gov idle up 1 to full V curve on the throttle and about 1700rpm

dle up 2 to 1900 or 1950 just to use round figures.

Ade

[LipolyGone]

Thanks Ade will set it up exactly like that sounds a very senceable setup.
I take it by the full V curve you mean 100 75 50 75 100 on my radio curves in idle up 1 & 2 or are you sugesting I only use the gov in idle up 2

[Ade_Law]

use the gov in idle up 1 too. and use 100, 75, 50, 75, 100

for those looking at this and throwing their helis around its also worth adding 35% elevator and aileron to throttle mix. so as you add cyclic you get an increase in throttle. it gives the gov a kick up the arse, rev lock then adds throttle before the rpm actually drops off.

Ade

[shuglu]

use the gov in idle up 1 too. and use 100, 75, 50, 75, 100

for those looking at this and throwing their helis around its also worth adding 35% elevator and aileron to throttle mix. so as you add cyclic you get an increase in throttle. it gives the gov a kick up the arse, rev lock then adds throttle before the rpm actually drops off.

Ade

Is this done in programme mix on a 9C?

[shuglu]

Just googled it...

Thanks to raptortechnique.

http://www.raptortechnique.com/throttlemix.htm

[Ade_Law]

the 9c super has swash -> throttle mix built in

Ade

[shuglu]

Just discovered it. With this setting, will the throttle servo be instructed to move before the revlock kicks in and get the jump on the lag.