Announcement

Collapse
No announcement yet.

CSM interface and power voltage

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    CSM interface and power voltage

    I just discovered while programming my CL1 that if the cyclic system is on 8.4volts (direct off a 2S lipo), while the CL1 will work no problem, the USB interface will only read and not write.

    Powering my system off a 4.8V nicad the programming works.

    This is a bit of a pain, 'cos now not only do I need a laptop to fiddle with it at the field but also I need to change the power supply too!
    www.heli-extreme.co.uk a good club in south Sheffield
    600n pro BeastX Align DFC head bls251, 3xbls451, align gov, 600d, 2in1
    trex500, BeastX DS510 swash, Beast X cutr and carve head DS520 HK3026-1900, Align 425D blades, 5S4200 rev'trix, K&BDD dampers, AR6200
    "450" superframeSTK, align DFC head v2tail, hk22281-8 on 3S 9650w9257gear commander 55A align 325D hitec digitals Tarot ZYX, AR6100e
    MCPX kbdd tail and blades, miniaviation bats

    Dont spend more flying models than it costs to fly for real
    Tags: None
  • #2
    CSM say the voltage shouldn't affect the USB.
    They said possibly my tx could have been affectingthe USB.

    I just hooked up on 8.4V with no Tx on and it works read and write.
    Looks like CSM were right.


    Can't try with my tx on becuase I left it on and its flat!
    www.heli-extreme.co.uk a good club in south Sheffield
    600n pro BeastX Align DFC head bls251, 3xbls451, align gov, 600d, 2in1
    trex500, BeastX DS510 swash, Beast X cutr and carve head DS520 HK3026-1900, Align 425D blades, 5S4200 rev'trix, K&BDD dampers, AR6200
    "450" superframeSTK, align DFC head v2tail, hk22281-8 on 3S 9650w9257gear commander 55A align 325D hitec digitals Tarot ZYX, AR6100e
    MCPX kbdd tail and blades, miniaviation bats

    Dont spend more flying models than it costs to fly for real

    Comment

    Previous template Next
    Working...
    X