GP750 reset??

[Nick B]

Anyone know if i can do this??

Its on my pro with a 620

Problem is no matter where i go on the limits it always binds turning left

Doesnt do what i put in,all my other 750's are fine,i even tried moving it 5mm eachway of centre but goes back to original limit setting,fine one way but binds tother way

[Geek]

the servo arm is too long so the Gyro doesn't see it moving far enough in the direction your having trouble.
move the linkage in on the servo end.
that is my guess

[Nick B]

Will try that paul,its a 520 not 620

[rapidgaz]

the servo arm is too long so the Gyro doesn't see it moving far enough in the direction your having trouble.
move the linkage in on the servo end.
that is my guess

Have seen this myself on the 750, so totally agree

[Nick B]

I had a look at the servo horn and its already on the inner hole

[rapidgaz]

Inner hole on what servo horn

[Geek]

also is the arm in the middle?
does it fly in normal ( non heading hold )?

just thinking that the linkage might be out so you have too much travel one way and not enough the other.

or are you do the end points the right way? left then right I think it is?
good luck

[Nick B]

Hey paul,i had the servo off earlier and the limit will go further so i guess the gyro is fine.I have been setting up the blades with zero pitch on my 750's but on the 450 when blade pitch is zero theres more travel one way so i have centred the slider and it dont bind no more,got slight pitch one way when in rate and will try it tomorrow

[Geek]

I bet it's fixed
got to be worth a thanks?
have fun

[Nick B]

THANKS MATEY!

[Nick B]

Inner hole on what servo horn

The horn is one as per manual