Tweet
I have a bit of an issue with an Align DS510 on my TRex 500. I've been setting up a BeastX on this heli and whilst working on it I have noticed that occasionally one of the cyclic servos will just stop responding to any stick movements. The only way to get it started again is to give a tap to the output arm (it only needs a very gentle push) -then it seems to work perfectly again for another few minutes.
I'm not sure but think I may have made this servo bind by mistake while I was trying to set up the cyclic correctly and guess I might have damaged it somehow but it's strange how it seems to work perfectly and then just stop for no apparent reason.
Has anyone had this happen? Any advice? If I fly it like this I think it will end in tears!
I'm not sure but think I may have made this servo bind by mistake while I was trying to set up the cyclic correctly and guess I might have damaged it somehow but it's strange how it seems to work perfectly and then just stop for no apparent reason.
Has anyone had this happen? Any advice? If I fly it like this I think it will end in tears!
Comment