Tweet
I recently bought a Flasher 450CF ARTF kit which came equipped with an Assan GA410 gyro and four 9g generic analogue servos. I immediately discarded the stock servos for a set of Savox SH0257-MGs. The set up is almost complete except I am struggling to set the throw on the rudder servo. The Tx and Rx are a Spektrum DX6i and AR6100, if that makes a difference.
With the Assen limit pot set to the maximum (240) and the sevo limits set to 125% in both directions on the Dx6i, I only get about half the throw needed to move the tail slider between it's extents.
Last night I tried a HK401 gyro as a test and the slider was able to move the entire range between the extents.
The Assan documentation is not exactly extensive. It does not mention explicitly whether the Gyro is compatible with digital servos. So I was wondering whether that was the problem and I should give up on the Assan, or whether there is something wrong with Gyro I have or the way I am trying to set it up.
Any help appreciated.
With the Assen limit pot set to the maximum (240) and the sevo limits set to 125% in both directions on the Dx6i, I only get about half the throw needed to move the tail slider between it's extents.
Last night I tried a HK401 gyro as a test and the slider was able to move the entire range between the extents.
The Assan documentation is not exactly extensive. It does not mention explicitly whether the Gyro is compatible with digital servos. So I was wondering whether that was the problem and I should give up on the Assan, or whether there is something wrong with Gyro I have or the way I am trying to set it up.
Any help appreciated.
Comment