BLS351 @ 8v

[sacko]

Is anybody doing this? Ideally I want to use my AR7100 at run them at 8v but dont want to take un-neccasary risks.

[dumb thumb it]

351 8v

hi paul

i dont know of any one running the bls351 on 8v. try asking on helifreaks and runryder there is lots of people in the us running the bls451 on 8v, in the us more people seem to use futaba servos ect .


alec

[sacko]

Good point, cheers. Just posted it up there too

[Jamin_00]

Hmm, Paul,

What machine you intending on running these on mate

[sacko]

Had a good look over it this morning and all looks good, just needs a new liner and will replace the clutch bell too. Does the liner come pre-fitted to the clutch bell?

Unsure if I should just run a 6v reg with the AR9000, or fit the neat Ar7100.

[Jamin_00]

If I had a 7100 I would use that

Had a good look over it this morning and all looks good, just needs a new liner and will replace the clutch bell too. Does the liner come pre-fitted to the clutch bell?

Can find out for you if no one already knows

[Tom Burgess]

Had a good look over it this morning and all looks good, just needs a new liner and will replace the clutch bell too. Does the liner come pre-fitted to the clutch bell?

Unsure if I should just run a 6v reg with the AR9000, or fit the neat Ar7100.

You could still fit the neat AR7100 Paul and use the neat Perfect reg inline 6V reg between pack and AR7100

[Jamin_00]

Paul, not 100% sure but I dont think it does, but will know soon

*Edit, I have been told it does not come with it

http://www.conceptcopters.com/store/...id_product=849

[sacko]

Cheers all. May have to install a reg too then. The perfect reg does look good too

Nice one Ben, will have to have a hunt for it.

[low.level.3d]

Hi,

Robbe now rated almost all BLS servos (escept bls251) and some receivers for direct 2S LIPO use!!

http://cms.robbe.com/downloads/Techn...ervos_2010.pdf

cheers,

cyril