Tweet
Hey All,
Im trying to get my RCE600 setup in my Rex 600 on a Futaba 10c. The manual only references the ATV settings for a 1024z or a 14mz. Anyone know what the ATV / RPM settings are on the 10c?
Ive got it on an aux channel at the mo so that i can use Idle 1 and 2 with or without the gov. I did give it a try but it seemed to bog under 10 degrees im guessing because the headspeed was too low for the pitch. I havent got a tach at the moment so cant check the rpm. I guess if someone has reference settings this should be a good place to start?
Any advice much appreciated.
Thanks in advance
Im trying to get my RCE600 setup in my Rex 600 on a Futaba 10c. The manual only references the ATV settings for a 1024z or a 14mz. Anyone know what the ATV / RPM settings are on the 10c?
Ive got it on an aux channel at the mo so that i can use Idle 1 and 2 with or without the gov. I did give it a try but it seemed to bog under 10 degrees im guessing because the headspeed was too low for the pitch. I havent got a tach at the moment so cant check the rpm. I guess if someone has reference settings this should be a good place to start?
Any advice much appreciated.
Thanks in advance
