Tweet
Savox servo issue:
My multiplex is now up graded to 2.4 this runs at two speeds 21ms & 14ms (same as normal futaba) but is 12bit 3872 resolution. Can I notice the difference? Sure brain and fingers hard wired! No at 44 I’m too old and slow however it does have that connected feeling and the servos (multiplex & Hitec) are fast and very very smooth. Unlike the savox servos I have, which can’t cope with the speed & frame rate, they lock out and run poorly unless the speed is reduced 21ms. No doubt some of you technically able chaps may be able to explain this to me. I thought as they were digital they should cope, my multiplex & futaba analogue servos are fine with this system. Anyone else have this problem with SH 0257 servos at high frame rates?
As a note both Multiplex and CML are being very helpful in investigating this and have sent a servo for testing.
My multiplex is now up graded to 2.4 this runs at two speeds 21ms & 14ms (same as normal futaba) but is 12bit 3872 resolution. Can I notice the difference? Sure brain and fingers hard wired! No at 44 I’m too old and slow however it does have that connected feeling and the servos (multiplex & Hitec) are fast and very very smooth. Unlike the savox servos I have, which can’t cope with the speed & frame rate, they lock out and run poorly unless the speed is reduced 21ms. No doubt some of you technically able chaps may be able to explain this to me. I thought as they were digital they should cope, my multiplex & futaba analogue servos are fine with this system. Anyone else have this problem with SH 0257 servos at high frame rates?
As a note both Multiplex and CML are being very helpful in investigating this and have sent a servo for testing.
Comment