Tweet
Why is it that i can put the gain right up from 75-80% right up to 150% with no noticable difference??? Surely the tail should be wagging more than an exited mut on speed?? It will hold regardless on full pitch climb outs. Oh it's a CSM 720 as most know anyway.
-
Yes the big sigpic is coming back -
What headspeed are you running? -
-
-
On the gear channel. As for HS??? i always run idle 2 100% flat but no idea on the actual headspeedYes the big sigpic is coming backComment
-
Have you tried moving the ball outwards on the servo arm? This provides more mechanical gain and allows a reduction in the Tx.
TRex 500 ESP VBar
Flybarless is more
Comment
-
Tried both out & in.Yes the big sigpic is coming backComment
-
Are you sending the gain signal to the right channel?
I had this once.
I was adjusting the endpoints on the gear channel (5) all the way from zero to 150 and it made no difference at all. Found out eventually that I had the gyro sens function enabled on the Tx (DSX9 for me) and the gain signal was in fact going to Aux 2 channel (7) so my adjustments weren't doing diddly squat!JR Vibe Fifty fb (YS56)Comment
-
+1 Ive had this tooOriginally posted by Steve View Post
Led me a bit of a dance for a while....
What length servo arm are you using ?, CSM recommend a min of 15mm from servo center to ball. Does the gyro have full use of the tail slider?
And as a thought, you havent changed anything with the pc interface that could limit the servo response?
SimonSWRCH ,
Oh.. And a Helix 700 Gasser, Hv with SK540.....with SAB HPS head.
Comment
-
Hey guys, I have seen this heli and the servo horn is the correct size for the tail. Logo 500 with a JR 8900G (Round disk) I'm using the same servo on my Logo 500 without issue. It's a gyro thing...
Comment
Comment