If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Took the servo out undid the screws carefully took casing apart (was going to do a pic) but before I cud take a note of the gears and where they were, one dropped out and I am stuck with not knowing where it goes........I know its a long shot but would anyone have a pic of the inside of Hitec HS65hb.......I just dont fancy taking another off and mucking that one up as well????
Comment