nes-591

[Boggy]

im just putting together another raptor titan from bits i have lying around! is a jr nes-591 strong enough for a pitch servo?? it will be running on 4.8v

specs are
Bearing Type:
Ball Raced
Dimensions:
34.5x19x38mm
Speed @ 4.8v:
0.24S/60 Deg.
Torque @ 4.8v:
5.1Kg/Cm
Weight:
36g


for just general flying around non of the flippy floppy spinny around nonsense!!!

[ChrisB]

Yes Ron,i used these a lot in my Rappy 50`s and in a 90.They are not the best but will serve the purpose to get the heli flying with what you have available rather than spend more money.

[Ade_Law]

they are strong enough but really arent very accurate. giving a soggy double centre sticky feeling kinda like your blade grip thrust races are in the wrong way but not as bad.

spend the extra on a 3152 defo worth it.

Ade

[Boggy]

i have some new 3152's ade but this was a s/h one i had in my box!! so i'll go with both of you guys advice, and probably try it then change it out at the field!!.

as for feeling like the blade grip thrust races in the wrong way round!! i most likely couldn't tell the difference!!!

[ChrisB]

Ron if you have a spare 3152 i would use that personally.

[Boggy]

as i say Chris i most likely will but i have three new ones . i will use the jr to see if this bag of bolts will fly first

its extremely low spec!! 620 woodies 591 on pitch ds821 on cyclics 601 gyro tinkered to use a 9254 tail servo!! and an old 50 sx engine.

ill be gob smacked if it gets airbourne!!

[Boggy]

look familiar??


total cost about £35.00