Futaba Bls251

[carpman]

I have just started setting up my tail with the above and spartan and noticed that i only get about 50% movement with full left stick compared to full right stick is this right ??????

[Tim Procter]

Is your rudder end points both set at 100%

[Made2Fade]

Have you been right through the spartan setup and set your endpoints? Also are you mounted at 90 degrees in normal rate mode?
Cheers
Lee

[carpman]

Yes BB i have even tried adjusting the travel adjust to 125 on left still no difference ....

Just looked in the monitor and thats showing the same full laft moves 1 bar full right moves 2 bars(using dx6i)

[carpman]

M2f not gone through spatan setup yet servo is at 90 in rate

[Tim Procter]

As Lee says go into the setup mode and adjust your endpoints on the gyro, You can adjust its travel each way via the setup.

[Made2Fade]

M2f not gone through spatan setup yet servo is at 90 in rate

Thats ya problem then mate Nothing to worry about, normal if you are 90 with the arm in rate mode and havent yet been through the setup.
Cheers
Lee

[chugga-bug]

Your not supposed to connect the servo till you've told the gyro the correct frame rate. Have you done this?
Do you get equal movement when you plug the servo direct into the RX?

[carpman]

ok chaps just lookin for setup vid (finless)aint got the flash link yet can it be done manually

[chugga-bug]

Yes. Read the booklet Dan. It's not too tricky to set up.

[Tim Procter]

No flash link needed.

Three hands would help though..

Up your gear end points to 90% each, Its helps accessing the setup.

Turn your TX on--->Toggle the gear switch on the TX when connecting the power to the gyro----->The gyro should go into setup mode.

1st step = Hold rudder stick to the left and toggle the gear switch once

2nd step = You are now setting the end points, Hold your rudder stick one way or the other and you will see the tail pitch slider moving each way. Make sure it doesnt bind when you then toggle the gear switch once again

3rd step as step 2. Set the end point in the opposite direction, When perfect toggle the gear switch for the last time.

Job done.

[Made2Fade]

But setup the correct pulse for your servo first as ChuggaBug said.
Cheers
Lee

[Tim Procter]

But setup the correct pulse for your servo first as ChuggaBug said.
Cheers
Lee

I knew I'd forgotten summat Lee..

[Made2Fade]

I knew I'd forgotten summat Lee..

Hey dont we all at some time mate

Cheers
Lee

[carpman]

Cheers chaps thanks for that all done now ....(was going to set up spartan next)

Everything working pucker now i think..........

Nearly ready for fuel