Jive 80 set up question

[DannyH]

Set up a jive 80HV for mode 1 and 4 with linear 0-100 throttle curve in normal mode on 8fg. realised afterwards that the throttle trim was pulled down fully.

Does this make a difference? I tried to repeat the set up with the trim in the middle (so I get a true -100 to +100 on servo screen) but the jive wont arm unless the trim is all the way down.

If it is ok to run this way should the trim remain down for the idle up conditions also?

Cheers

Dan

[GIXERMAN]

Trim down on both off my 120s, only norm mode, leave trim alone in id1 ,2

[DannyH]

Jive 80 set up question

Cheers,

[Jamin_00]

Re: Jive 80 set up question

Set up a jive 80HV for mode 1 and 4 with linear 0-100 throttle curve in normal mode on 8fg. realised afterwards that the throttle trim was pulled down fully.

Does this make a difference? I tried to repeat the set up with the trim in the middle (so I get a true -100 to +100 on servo screen) but the jive wont arm unless the trim is all the way down.

If it is ok to run this way should the trim remain down for the idle up conditions also?

Cheers

Dan

The Jive dies not need to arm to go in to set up. Set your curve abd put the trim to centre, plug your packs in and a few seconds later pull the jumper out and it will go in to set up mode so you can do it again

[DannyH]

Jive 80 set up question

Thanks Ben