Tweet
What pyro motor do i need for the synergy E7, i know its a 700-45 but do i need long or short shaft? 12s 13t pinion
Or if anyone has one for sale before i order.
Or if anyone has one for sale before i order.
-
Troll buster
sigpic
-
Er, think I got the 45L, best ask Tim as I brought it off him and I not sure lol what pinion I using either!!
Does only 1 come with the kit or 2? I'm using whatever was in the kit.
Can look in the morning as my E7 is at the office.
+ 7 x Eddies finest EGS's
-
The kit will come with both 14T and 15T pinions for use with the most common motor choices for either E6 or E7 configuration.
With the motor, you will require a motor with a shaft length of at least 30mm to properly engage the lower support bearing for the motor shaft.
Hope this helpsThanks!
Rossco
sigpic
Synergy N7 / Synergy E7SE / Synergy E5
Synergy R/C Helicopters / Rail Blades / Fast-Lad Performance Flight Team
Equipment for Sale:
Comment
-
My mate had a 700/45 long shaft in his.Henseleit TDR
V-Bar x2
SAB Goblin 700 V-Bar
SAB Black Nitro V-Bar YS91 Tareq SRX
T-Rex 700e DFC V-Bar
T-Rex 700N MAJ DFC V-Bar YS91 Tareq SRX
Synergy N7 V-Bar OS105 HZ-R
Synergy E7se V-Bar
Synergy N5c FBL V-Bar
Gaui NX7 V-Bar YS91 Tareq SRX
T-Rex 550 E FBL V-Bar
Gaui NX4 V-Bar
V-Control
Proud owner of TWO!! Platinum Stars!
Comment
-
I'm using a Scorpion 4035 450 long shaft with a 13 tooth pinion . A sort shaft will be no good as it wont reach the bottom support bearing !Comment
Comment