Tweet
I just thought i'd share my IR's with you. I have 2 25C 5000's (not nanotech) one with 138 cycles & the other with 31 cycles. The older one's IR is now reading on the Cellpro 10s 9.7 3.8 3.5 3.5 3.7 3.5. The newer one is 8.1 2.2 2.1 2.0 2.2 2.2. When i recieved the new one that first cell read 14 & i was going to email them but i decided to just use it instead. I also have a 30C but that's not doing very well at 125 cycles & i'm sticking with 25C. Also i only use around 70-75% max each flight.
-
Yes the big sigpic is coming back -
Niiiiiice :s
Hopefully the new one is useable.mit I'll just be the first cell to go.
x 3 -
Funny on my turnigy packs cell 1 aleays seems to have the highest or but there all still under 3 after 80+ flights one is creeping towards 4 but 100 cycles old and still
No puffing
Sent from my iPhone using TapatalkT-Rex 500 ESP FBL, BeastX
8FG Super
MCPX with DX6Comment
-
Hi are you taking the IR reading on a cellpro ?? If so you may have the wrong node wiring enabled that make one of the cell Ir,s read very high. I had this prob with my v2 8 all my batts had an high ir on one cell untill i put it in the right mode.Goblin 700 comp 3 blade Kyle stacey head and tail, 160 scorpion esc , ultimate motor,MKS. Vbar NEO
Trex 700 DFC Dominator motor, scorpion . MKS. Vbar NEO
iCharger 4010 , PL8 charger,
Vbar Control and a case of lithium plus an eu10i genny !!!Comment
-
Forgot to say all my nanotechs read between 3 - 4 on all cellsGoblin 700 comp 3 blade Kyle stacey head and tail, 160 scorpion esc , ultimate motor,MKS. Vbar NEO
Trex 700 DFC Dominator motor, scorpion . MKS. Vbar NEO
iCharger 4010 , PL8 charger,
Vbar Control and a case of lithium plus an eu10i genny !!!Comment
-
Yea i don't get why it's always cell1?? weird. But yea both packs still good for 3D (well my 3d), the 138 cycle is used in my last vid & the newer one obviously really goodYes the big sigpic is coming backComment
-
Yes, how to i check & change that mode??Originally posted by jasoncook View PostYes the big sigpic is coming backComment
-
Have a look at the instructions ?? mine had early software installed which did not have the option to change the node mode, it had me baffled for a while then i updated the software and the option was there. Are you using the cellpro balance board i was not so that was my problem.Goblin 700 comp 3 blade Kyle stacey head and tail, 160 scorpion esc , ultimate motor,MKS. Vbar NEO
Trex 700 DFC Dominator motor, scorpion . MKS. Vbar NEO
iCharger 4010 , PL8 charger,
Vbar Control and a case of lithium plus an eu10i genny !!!Comment
-
instructions
lol i asked you 
Yea cellpro ballance board. I'll have to check instructions now.
Yes the big sigpic is coming backComment
Comment